7. Electrical Installations 71
• This key is used to save and recall the setting of individual
lights. Press briefly on the desired memory button to recall
the last saved setting of all switchable 12 V lights. Press
• Press this button to switch the entrance light on and off. It is not
possible to switch this light on when the engine is running. The
light will turn off automatically when the engine is started.
The awning light must be switched off when the van is on
the road.
• Briefly press the button to switch the kitchen lamps on and
off.
• Briefly press the button to switch on the indirect lighting in
the living area.
LED ambient lighting
Memory buttons
Awning light
*
Kitchen light
The wall lamps themselves must be switched on before they
can be controlled by using the control panel.
• Briefly press the corresponding button to switch each
lamp on and off. Press longer on the button to regulate
how brightly you want the lights to shine. The brightness
you set will be saved; when the lights are switched on
again, the brightness you originally set will also be swit-
ched on again. If the system's power supply is interrupted,
the wall light will shine on full the first time you switch it on.
If the intensity has been reduced to a minimum by dimming
the lights, the lamp will switch itself off. Since this setting is
saved, the dimmer must be reset to the brightest level before
the lamp will shine again. For technical reasons, if the lamp
is set to the very lowest dimmed level, the light may flicker. If
this bothers you, please increase the brightness of the light.
Wall lights / lighting
in the dinette
Ceiling Lamp
This key is not assigned in the Ontour series.
(optional for Ontour series)
longer on this button to save the setting of a light. These
memory buttons are not used to save the settings of the
230 V electrical devices (
e.g. hot-air heating
).
