8 Channel 2.4 GHz Aircraft Computer Radio System
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 6: Heli Programming Menu
Section 6: Heli Programming Menu
98
99
Revolution Mixing cont.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the top
right corner of the screen will indicate when the mix is active.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight the
switch position that you will use to enable revolution mix. Press
the jog dial to confirm your selection.
If you are using multiple flight conditions, you must define REVO Mix values for each flight
condition. The top field of the REVO Mix menu allows you to select the desired flight condition.
Alternately, you may select the desired flight condition using the assigned F.Cond switch.
Note
Tip
Tip
Tip
To disable the revolution mix:
1. Scroll to highlight the “MIX” field in the Revolution Mix menu
and press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the Back button to return to the Model Function menu.
17. The “I/O” (input/output) field is display only. It shows the value of the tail rotor pitch and throttle as
you actuate the contros. These values are reflected in the graph as well.
18. To set up the Revo Mix in accordance with a Flight Condition:
− The upper right field of the menu displays which flight
condition is currently active and will be programmed.
− Scroll to the Flight Condition field and press the jog dial to
activate the menu.
− Choose the desired flight condition and press the jog dial to
confirm your selection.
19.. Press the Back button to return to the Model Function menu.
Swash to Throttle Mixing
A swash to throttle mix is typically used to increase main rotor RPM when a swash control command is
input to the helicopter. The increased RPM compensates for the loss of lift due to tilting the rotor.
1. From the Model menu, rotate the jog dial to highlight
“SWASH>THRO” and press the jog dial once to enter the
activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to confirm your selection and activate the swash-throttle
menu.
4. Scroll to the function field (“AILE” or “ELEV”). If “AILE” is not
the current function, press the jog dial to activate the menu.
Otherwise, skip to step 6.
5. Scroll to select “AILE” and press the jog dial to confirm your
selection.
6. Scroll to the top row of the value table (“AILE”) and press the
jog dial to activate the menu.
7. By scrolling, you can highlight either the “L/U” (left/up), the
“R/D” (right/down) field, or both fields. If you want the swash to
throttle mix to be the same for both directions of aileron swash
travel (most common), highlight both fields and press the jog
dial.
8. Rotate the jog dial to input the desired throttle compensation
when a left roll command is given. Press the jog dial to confirm
your input.
9. Scroll to highlight the “EXP” field and press the jog dial to
activate the selection.
10. Rotate the jog dial to input the desired exponential travel of
the throttle servos when reacting to this mix. The setting does
not affect exponential travel of the servo when throttle stick
inputs are given.
