8 Channel 2.4 GHz Aircraft Computer Radio System
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
Section 5: Acro and Glider Programming Menu
88
89
Throttle Cut (Acro Only) cont.
Throttle Curve (Acro Only) cont.
Throttle Curve (Acro Only)
The Throttle Curve function allows you to modify the normally-linear servo rate movement for throttle by
defining five different points along the throttle response curve.
To disable throttle cut:
1. Scroll to highlight the “MIX” field in the throttle cut menu and
press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to confirm your
selection.
3. Press the Back button to return to the model function menu.
To configure a throttle curve:
1. From the model menu, rotate the jog dial to highlight
“T.Curve” and press the jog dial once to enter the activation
menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to confirm your selection and activate the throttle curve
menu.
4. Scroll to the “1” field and press the jog button to activate the
menu.
5. Rotate the jog dial to input the desired throttle position at this
point on the curve (Throttle stick full down).
6. Scroll to highlight the “2” field and press the jog dial to
activate.
7. Rotate the jog dial to set the desired value of “Y” axis on the
left when right roll command is given. Press the jog dial to
confirm your input.
- Scroll to select “ON” and press the jog dial to confirm your
selection. If you toggle the selected switch, the field in the top
right corner of the screen will indicate when the mix is active.
The momentary “deadman” switch (Switch-H) is a convenient and commonly-used throttle cut
switch. Throttle cut should be off when the switch is in its neutral position.
Note
Tip
Tip
Tip
Caution
8. Press the back button to return to the model function menu.
10. Scroll to the “EXP” (exponential) field and press the jog
button to activate the menu.
11. Rotate the jog dial to select “OFF” or “ON”. When “ON” is
selected, the points in the curve are connected with exponential
curves. Otherwise, the points are joined linearly. Press the jog
dial to confirm your selection.
12. Scroll to highlight the “OST” (Offset) field and press the jog
dial to activate the menu.
13. Scroll to select the desired amount of offset and press the
jog dial to enter your selection.
14. Scroll to highlight “S/W” and press the jog dial to activate the
switch menu.
