8 Channel 2.4 GHz Aircraft Computer Radio System
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
Section 5: Acro and Glider Programming Menu
64
65
Aileron Differentials cont.
You can customize individual travel values in the “AILE” and “AIL2” fields by scrolling to those
fields and activating the sub-menus.
Note
Tip
Tip
Tip
6. Press the back button to return to the model function menu.
Elevon Mixing
Flying wing aircraft are most often set up using elevon control surfaces. The Flash 8 mixes the aileron and
elevator functions to provide this configuration with just one flight control surface per wing panel.
It is not necessary to access or change this menu to fly an elevon-equipped aircraft. The default
values are 100% in all directions.
Note
Tip
Tip
Tip
Caution
1. From the model menu, rotate the jog dial to highlight “Elevon
Mix” and press the jog dial once to enter the elevon mix menu.
4. Scroll to the “S/W” field and press the jog dial to activate the
menu.
5. Rotate the jog dial to select a switch to control aileron differential
settings. Press the jog dial to confirm your selection. If you choose
the “NULL” option, the current settings will remain active at all times
for this model. If you choose a switch, repeat steps 2-4 to define the
settings for each switch position.
If you are using multiple flight conditions, you must define aileron differential values for each flight
condition. The top field of the AIL DIFF menu allows you to select the desired flight condition.
Alternately, you may select the desired flight condition using the assigned F.Cond switch.
Note
Tip
Tip
Tip
2. Scroll to the top “AILE” field and press the jog dial to activate
the menu.
Elevon Mixing cont.
3. Scroll to highlight the “L/U” (left/up) field and press the jog dial to
activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo attached
to the “AILE” receiver slot. This value regards the servo travel
when a left roll command is given. Press the jog dial to confirm
your input.
5. Scroll to highlight the “R/D” (right/down) field and press the
jog dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease (counter-
clockwise) the desired servo endpoint when a right roll command is
given. Press the jog dial to confirm your input.
7. Press the back button to return to the elevon mix menu.
8. Scroll to the top “ELEV” field and press the jog dial to activate
the menu.
9. Scroll to highlight the “L/U” (left/up) field and press the jog dial to
activate the menu.
10. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo attached
to the “ELEV” receiver slot. This value regards the servo travel
when a left roll command is given. Press the jog dial to confirm
your input.
11. Scroll to highlight the “R/D” (right/down) field and press the jog
dial to activate the menu.
12. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a right roll
command is given. Press the jog dial to confirm your input.
13. Press the back button to return to the elevon mix menu.
14. Repeat steps 2-13 using the lower “AILE” and “ELEV” fields to set the servo endpoints when pitch
(elevator) commands are given.
