8 Channel 2.4 GHz Aircraft Computer Radio System
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
Section 5: Acro and Glider Programming Menu
68
69
V-Tail Mixing cont.
16. Scroll to select “rev” and press the jog dial to confirm your selection. Verify that the control surfaces now
move in the correct direction.
17. Push the back button twice to return to the model function menu.
If you are using multiple flight conditions, you must define elevon values for each flight condition.
The top field of the Elevon Mix menu allows you to select the desired flight condition. Alternately,
you may select the desired flight condition using the assigned F.Cond switch.
Note
Tip
Tip
Tip
Ailevator Mixing
The Ailevator feature allows the configuration of a two-servo or “split” elevator setup. It also features an
“aileron to split elevator” mix which allows the elevators to provide roll control. This feature, also called
“tailerons”, is commonly used on jet models.
2. Scroll to the top “ELEV” field and press the jog dial to activate the
menu.
3. Scroll to highlight the “L/U” (left/up) field and press the jog dial
to activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo attached
to the “ELEV” receiver slot. This value regards the servo travel
when a pitch up command is given. Press the jog dial to confirm
your input.
5. Scroll to highlight the “R/D” (right/down) field and press the jog
dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a pitch
down command is given. Press the jog dial to confirm your
input.
1. From the model menu, rotate the jog dial to highlight “Ailevator”
and press the jog dial once to enter the V-tail mix menu.
7. Press the back button to return to the ailevator menu.
8. Scroll to the top “ELE2” field and press the jog dial to activate
the menu.
9. Scroll to highlight the “L/U” (left/up) field and press the jog dial to
activate the menu.
10. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo attached
to the “RUDD” receiver slot. This value regards the servo travel
when a left roll command is given. Press the jog dial to confirm
your input.
11. Scroll to highlight the “R/D” (right/down) field and press the
jog dial to activate the menu.
12. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a right roll
command is given. Press the jog dial to confirm your input.
13. Press the back button to return to the ailevator Mix menu.
14. Repeat steps 2-13 using the lower “ELEV” and “ELE2” fields to set servo endpoints when pitch (elevator)
commands are given.
If you are using multiple flight conditions, you must define ailevator values for each flight condition.
The top field of the AILEVATOR menu allows you to select the desired flight condition. Alternately,
you may select the desired flight condition using the assigned F.Cond switch.
Warning
Note
Tip
Tip
Tip
Caution
Ailevator Mixing cont.
15. If elevator and/or aileron functions operate in the incorrect
direction, highlight the direction field (“nor”) under the reversed
function and press the jog dial to activate the menu.
16. Push the back button twice to return to the model function menu.
