8 Channel 2.4 GHz Aircraft Computer Radio System
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 7: Using the Telemetry System
Section 7: Using the Telemetry System
114
115
Battery
The Battery screen displays the voltage of the receiver battery (no sensor is required for this data).
Additionally, this screen displays flight pack voltage, motor current, and motor wattage for electric-
powered models.
Required Sensor:
HTS-C50 50-Amp Current Sensor or HTS-C200 200-Amp Current Sensor
1. From the sensor menu, rotate the jog dial to highlight
“BATTERY” and press the jog dial once to enter the battery
menu.
2. Scroll to select the “RX. BATT” and press the jog dial to activate
the menu.
3. Rotate the jog dial to check the Max. & Min. value and press
the back button to reset.
Receiver battery voltage is also displayed on the lower right corner of the Flash 8 home screen.
Note
Tip
Tip
Tip
Caution
4. Scroll to the “L.WAR” and press the jog dial. Rotate the jog
dial to select the low voltage alarm setting, press the jog dial to
confirm your selection.
5. Scroll to the “ALARM” and press the jog dial to confirm your
selection. Rotate the jog dial to select either “ON” of “OFF”. Press
the back button to return to the battery menu.
6. Scroll to select the “CURRENT” and press the jog dial to
activate the menu.
7. Rotate the jog dial to select the “C50” or “C200” and press the
jog dial to confirm your selection.
8. Press the back button to return to the sensor menu.
Advanced
The Advanced screen displays airspeed data collected from Hitec’s dedicated airspeed sensor (not GPS),
as well as rate-of-climb data collected by a variometer.
Required Sensor:
HTS-AS Air Speed Sensor and HTS-VM Variometer Sensor (both sensors are compatible
only with the HTS-SS Advanced Sensor Station)
1. From the sensor menu, rotate the jog dial to highlight
“Advanced” and press the jog dial once to enter the advanced
menu.
2. Scroll to the “CLIMB SOUND” field and press the jog dial to
confirm your selection.
3. Scroll to select “ON” if you would like the transmitter to emit a
tone when the model is gaining altitude. Otherwise, select “OFF”.
Press the jog dial to confirm your selection.
4. Scroll to the “SINK SOUND.” field and press the jog dial to
confirm your selection.
Servo
The Servo screen displays the current draw for each servo attached to the outputs of the Servo Manager
sensor.
If multiple servos are attached to a single sensor output using a Y-harness, the display will show
the total amperage for all servos connected to that output.
Warning
Note
Tip
Tip
Tip
Caution
Required Sensor:
HTS-SM Servo Manager Sensor (compatible only with the HTS-SS Advanced Sensor Station)
1. From the sensor menu, rotate the jog dial to highlight “Servo”
and press the jog dial once to enter the Servo screen.
2. Press the back button to return to the sensor menu.
