8 Channel 2.4 GHz Aircraft Computer Radio System
Section 4: Common Model Programming Menu
45
8 Channel 2.4 GHz Aircraft Computer Radio System
Section 3: System Menu Programming
44
Management Menu cont.
15. Scroll to highlight “FLIGHT CONDITION” and press the jog dial
to activate the menu.
16. Scroll to select “ON” or “OFF”. When the flight condition
warning is turned on, the radio will warn you if any programmed
flight conditions are active when the unit is powered on. Press
the jog dial to confirm your selection.
17. Scroll to highlight “FEEDBACK” and press the jog dial to
activate the menu.
18. Scroll to select “OFF”, “VIBRO”, “TONE”, or “T/V”. The three
types of cues when a warning condition is met are a flashing
light on the front of the transmitter, vibration, and beeping.
When feedback is turned off, the flashing light will be the only
indicator. When set to “VIBRO”, the light and vibration will be
active. When set to “TONE” the light and beeping will be active.
When set to “T/V”, all three indicators will be active during a
warning condition. Press the jog dial to confirm your selection.
INFO
The Info screen displays the current firmware information for the
radio.
1. From the system menu, highlight “INFO” and press the jog dial
once to see the information.
2. Press the back button to return to the system menu.
The Model Function menu contains options that relate to all model types (common) as well as options
which are specific to fixed wing models (ACRO/GLID) or helicopters (HELI). This section illustrates the
common model function options. The features specific to fixed wing or helicopter model types are
covered in Section Five and Section Six respectively.
Common Model Programming Menu
If you have not already programmed a model with the preceding quick start guide, we
encourage you to do so before tackling the model programming section of the manual.
Warning
Note
Tip
Tip
Tip
Caution
From the Model Function menu, you can program the following common functions:
REVERSE:
Specify the direction that a servo will travel with a given control input.
SUB TRIM:
Fine-tune the neutral point of a servo.
D/R & EXP:
Specify Dual-Rate and Exponential settings for control surface servos.
EPA:
Specify the servo travel limits for channels 1-8.
S.Speed:
Specify the transit speed for servos on channels 1-8.
PROG.MIX:
Configure up to five user-programmable mixes.
TIMER:
Configure two user-programmable timers.
MONITOR:
Observe graphic feedback to control inputs.
THRO Lock:
Assign a switch to lock and release throttle movements.
Working with the Common Model Function Menus
1. Turn on the transmitter. When prompted with the “Ready to
transmit?” message, highlight “NO” and press the jog dial.
2. To access the model function menu, press and hold the jog
dial.
3. The menu options shown reflect the parameters defined for
the active model in the model type menu (Model Type, Wing,
Tail, Swash). Common model items are integrated with the fixed-
wing and helicopter-specific options in the menu.
