Chapter IV Function Parameter Table
92
Parameter
Code
Parameter
name
Parameter detailed description
Minimum
Unit
Factory
value
Change
pulses/number of pulses per revolution ×
circumference of the measuring shaft.
4. When the actual length (U0.15) ≥ the
set length (FC.11), the drive will
automatically send a stop command to
stop. You need to clear the actual length
before running again, otherwise it will not
start.
Note: The multifunctional input
terminal can be used to clear the actual
length (DIx is defined to No. 24
function), the normal counting and the
actual length calculation can be
performed only after the terminal is
disconnected.
The actual length is U0.15, and it is
automatically stored during power
failure.
FC.13
Pulse per
revolution
1
1
○
FC.14
Dead zone
compensat
ion
coefficient
Set range: 0
～
20
1
Model
determina
tion
×
FC.15
STOP key
stop
function
selection
0: Only valid for keypad control
1: Valid for all control modes (invalid in
two-wire control mode)
1
0
○
FC.16
Digital
potentiom
eter power
failure
save
selection
0: The digital potentiometer frequency is
not saved during power failure, and will
start from 0.00Hz after power-on.
1: The digital potentiometer frequency is
saved during power failure, and will start
from the power failure frequency after
power-on.
1
1
○
FC.17
The first
shortcut
parameter
display
selection
Set range: 0
～
31
When set to 0
～
28, it corresponds to
group U0 parameter number; when set to
29, it displays the operation frequency
during fixed operation, and displays the
instruction frequency during standby;
when set to 4, it displays the operation
speed during fixed operation, and displays
the instruction speed during standby;
when set to 5, it displays the operating
linear speed during fixed operation, and
displays the instruction linear speed
during standby.
1
31
○
FC.18
Speed
displa
y factor
Set range: 0.01
～
100.00
This function code is used to correct the
display error of the rotation speed and has
no effect on the actual rotation speed.
Note: Speed =
0.01
1.00
○