Chapter II Installation and Wiring of Drive
22
Remove the keypad
Please refer to 2-10 to 2-13 to remove cover plates
Press groove 1 on both sides of the keypad with your fingers as shown in Figure 2-14, and then
take out the keypad body in direction 2.
Install the keypad
Insert the network cable into the network port in the control box as shown in Figure 2-15, and
insert the other end onto the keypad, and then press down the keypad in the arrow direction until
a “click” sound is heard. Never install the keypad from other directions, otherwise it may cause
poor contact of the keypad.
Figure 2-14 Removal of Keypad
Figure 2-15 Installation of Keypad
2.3 Wiring of main circuit terminals
Figure 2-16 Basic Wiring of Main Circuit