HIKVISION Pyronix EURO 280, Programming Manual, Page: 8 / 72

Page | 8
Set / Unset System
If you do not have access to a user code, setting and unsetting the system can be done using
the engineer’s code.

Enter Engineer Code (default
1111).

“ SET / UNSET SYSTEM ?” will
be displayed

Press the  key
Select the Area(s) you would like
to set. Press the

key. The
system then will begin to set. To
unset the areas, enter the
engineer code, and wait a couple
of seconds. ‘
SET / UNSET
SYSTEM’ will be displayed, press
the

key. To unset the areas,
press the

key.
NOTE: If the system has been set by any other code, the Engineer code will not unset
it.
Forced Arm on Inputs
The ‘Forced Arm On Inputs’ allows the Engineer to set the system using the Engineer Code,
forcing it to Set despite inputs in fault condition, and nominate which inputs must be triggered
to generate an alarm condition. This is a useful feature if you need to test a system in a
building where people are walking around.
NOTE 1: The system will give the correct
DigiCom response to the Setting, and any resulting alarm. On unsetting the system
(With the Engineer code or the User code), the system will revert to normal mode.

Enter Engineer Code (default
1111).

Any active faults will be
displayed, press the
 key.

Press the  key again.

‘ FORCE ARM ON 1 st INPUT? ’
will be displayed

Select the first input to be
forced armed and press the
 key.

Select the second input to be
forced armed and press the

key.
Select the area(s) / level set you
would like to set. Press the

key. The system then will begin to
set.
When the input is triggered, the
alarm will be activated.
Please note the primary Areas are
A,B,C and D.