Page | 13
Wireless Device Control
4.1.6 Wireless ZEMs
If a wireless ZEM is installed on the EURO panel, the learning (and deleting) procedure for the
wireless inputs and bells are performed in this function. It is recommended that all wireless
devices are learnt at the wireless expander before any installation /mounting is done. This is
so the signal strength (In Diagnostics, see page: 52) can be tested afterwards in order to
check the location of the wireless device is acceptable.
4.1.7 Programming Keyfob Buttons
In order for the engineer to program any keyfob buttons, the keyfob must first be learnt in the
Master Manager menu (and assigned to a user).
[0] No action: Disables the button
[1] Show Status: If the keyfob is learnt, the LED will indicate the status of the system when
the nominated button is pressed. GREEN = Unset. RED = Set.
[2] Set Area: Sets the chosen area
[3] Unset Area: Unsets any the chosen area on the system
[4] Operate User Output: Triggers a programmable output when the nominated button is
pressed. (See page 43 for user output programming)
[6] Hold-Up Output: Activates a hold up output (programmed in Engineers only)
Wireless Device Control
Using the
and
keys, scroll to
‘
WIRELESS DEVICE CONTROL?
’. Press
the
key
Control Inputs
To learn/delete inputs, press the
key,
or press
to learn/delete bells.
Learn Devices
To learn a new wireless device to the
wireless ZEM, press the
key. Press the
key to delete inputs.
Available/Learnt
Use the
and
keys or enter the
input number to select the relevant input
that is to be learnt and press the
key.