HIKVISION Pyronix EURO 280, Programming Manual, Page: 51 / 72

Page | 51
be tested. To remove an input from the
list, enter its number again. Press

Soak Days Left
Enter the number of days the soak test
will last. Press the

key. Initial
Soak: Enter the number of days the
soak test will revert to in the event a
soak input is triggered during testing.
This is recommended to be greater
than or equal to “Soak Days Left.”
Press the

key. ‘Soak Control’ will
be displayed, press the

key.
Test Siren?
To Test the Siren press the

key. All
outputs programmed as either Siren, or
Strobe will be tested. ‘Testing Siren’
will be displayed. Press the
 key to
stop the test. ‘Test Siren’ will be
displayed, press the

key.
Do Battery Load Test?
To perform a Battery Load Test, press
the

key. The Battery Load test will
be started. Once the Battery test has
completed, the LCD will display
whether the battery has ‘passed’ or
‘failed’ press the

key, ‘Do Battery
Load Test’ will be displayed, press the

key.
Test Outputs?
This tests all the outputs on the control
panel (including outputs on ZEMs,
Output Modules, and ATE pins) To test
the outputs press the

key. Select
the Output type you would like to test
(see page 38 for the output types) and
press the
 key.
All outputs programmed as the type
selected will be active. Press the

key. The outputs will switch off. Repeat
for other output types as required.
Press the

key. ‘Test outputs’ will be
displayed. Press the

key. You will
be returned to the Engineer Menu.
Test Communications?
If you would like to test SIA or Contact
ID communications, press

’Are You
Sure?’ will be displayed. Press

again and a test signal will be sent to
the ARC. Press
