Note
If you select Access Controller: If connect the device to a terminal via the RS-485 interface, set
the RS-485 address as 2. If you connect the device to a controller, set the RS-485 address
according to the door No.
4. Tap the back icon at the upper left corner and you should reboot the device if you change the
parameters.
7.2.3 Set Wiegand Parameters
You can set the Wiegand transmission direction.
Steps
1. Tap Comm. (Communication Settings) on the Home page to enter the Communication Settings
page.
2. On the Communication Settings page, tap Wiegand to enter the Wiegand tab.
Figure 7-6 Wiegand Settings
3. Enable the Wiegand function.
4. Select a transmission direction.
●
Output: A face recognition terminal can connect an external access controller. And the two
devices will transmit the card No. via Wiegand 26 or Wiegand 34.
●
Input: A face recognition terminal can connect a Wiegand card reader.
5. Tap to save the network parameters.
Note
If you change the external device, and after you save the device parameters, the device will
reboot automatically.
DS-K1TA70 Series Face Recognition Terminal User Manual
40
