Overtime Level for Workday
When you work for certain period after end-work time on workday, you will reach different
overtime level: overtime level 1, overtime level 2 and overtime level 3 . You can set different
pay rate for three overtime levels, respectively.
Pay Rate
Set corresponding pay rates for three overtime levels, which can be generally used to
calculate total work hours.
Overtime Rule for Non-Workday
You can enable overtime rule for non-workday and set calculation mode.
4. Click Save.
Configure Attendance Check Point
You can set the card reader(s) of the access point as the attendance check point, so that the
authentication on the card readers will be recorded for attendance .
Before You Start
You should add access control device before configuring attendance check point. For details, refer
to Add Device .
Steps
Note
By default, all card readers of the added access control devices are set as attendance checkpoint.
1. Enter the Time & Attendance module.
2. Click Attendance Settings → Attendance Check Point to enter the Attendance Check Point
Settings page.
3. Optional: Set Set All Card Readers as Check Points switch to off.
Only the card readers in the list will be set as the attendance check points.
4. Check the desired card reader(s) in the device list as attendance check point(s).
5. Set check point function as Start/End-Work, Start-Work or End-Work.
6. Click Set as Check Point.
The configured attendance check point displays on the right list.
Configure Holiday
You can add the holiday during which the check-in or check-out will not be recorded.
DS-K1A802A Series Fingerprint Time Attendance Terminal User Manual
88
