Note
●
The displayed parameters may vary for different access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Information page, click More to
edit the parameters.
Name
Edit the card reader name as desired.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less than the set value, the card
swiping is invalid. You can set it as 0 to 255.
Alarm of Max. Failed Attempts
Enable to report alarm when the card reading attempts reach the set value.
Max. Times of Card Failure
Set the max. failure attempts of reading card.
Card Reader Type/Card Reader Description
Get card reader type and description. They are read-only.
Default Authentication Mode
View the default card reader authentication mode.
Fingerprint Capacity
View the maximum number of available fingerprints.
Existing Fingerprint Number
View the number of existed fingerprints in the device.
4. Click Advanced and you can configure more parameters.
Enable Card Reader
Enable the function and you can operate the functions below on the card reader.
Buzzer Polarity
Set Buzzer Polarity of main board according to the card reader parameters. Generally, adopts
the default settings.
Max. Interval When Entering PWD
When you inputting the password on the card reader, if the interval between pressing two
digits is larger than the set value, the digits you pressed before will be cleared automatically.
Fingerprint Recognition Level
Select the fingerprint recognition level from the drop-down list.
Fingerprint Recognition Interval
Select the fingerprint recognition interval from the drop-down list.
5. Click OK.
DS-K1A802A Series Fingerprint Time Attendance Terminal User Manual
67
