HEIDENHAIN TNC 620 E, User Manual

Page: 756 / 840

MOD Functions | Setting up data interfaces
19
756
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Data transfer between the control and TNCremo
Check whether the control is connected to the correct serial port
on your PC or to the network.
Once you have started TNCremo, you will see a list of all files that
are stored in the active directory in the upper section of the main
window
1 . Using <File>, <Change directory>, you can select any
drive or another directory on your PC.
If you want to control data transfer from the PC, establish the
connection with your PC in the following manner:
Select <File>, <Setup connection>. TNCremo now receives the
file and directory structure from the control and displays this in
the lower part of the main window
2
To transfer a file from the control to the PC, select the file in the
control window per mouse click and move the highlighted file
into the PC window while holding down the mouse button
1
To transfer a file from the PC to the control, select the file in the
PC window per mouse click and move the highlighted file into
the control window while holding down the mouse button
2
If you want to control data transfer from the control, establish the
connection with your PC in the following manner:
Select <Extras>, <TNCserver>. TNCremo then starts in server
mode and can receive data from the control or send data to the
control
You can now call the file management functions on the control
by pressing the
PGM MGT
key in order to transfer the desired
files
Further information: "Data transfer to or from an external data
carrier", page 194
If you have exported a tool table from the control, then
the tool types are converted to tool type numbers.
Further information: "Available tool types", page 266
End TNCremo
Select <File>, <Exit>
You can open the context-sensitive help function of the
TNCremo
software by pressing the
F1
key.