DPO6000
，
MPO6000 Series Digital Phosphor Oscilloscope Instruction V1.1
- 81 -
with the
Standard waveform shapes buttons
. Select one of the standard waveform
shapes and then set the number of cycles, and it will draw the requested number of cycles
of the waveform.
:
Minimum.
When one of the
Standard waveform shapes buttons
is
pressed, this control sets the minimum signal level.
:
Maximum.
When one of the
Standard waveform shapes buttons
is
pressed, this control sets the maximum signal level.
:
Duty cycle.
When a square, triangular or ramp waveform is selected
using one of the
Standard waveform shapes buttons
, this control sets the duty cycle of
the signal.Duty cycle is defined as the time that the signal spends above zero volts divided
by the total cycle time. Thus, a symmetrical square or triangular wave has a duty cycle of
50%.Reducing the duty cycle shortens the positive part of the cycle and lengthens the
negative part.
Note
:The
Frequency, Amplitude, Offset
parameter of the ARB waveform can not be
regulated in this WaveEditor software, but it can be done by tuning on the device directly
after the waveform data is downloaded to device .
Do not use the WaveEditor and the DSO software at the same time, it will cause errors.
Output Arbitrary Waveform
1.Press the
【
Wave Gen
】
button on the front panel to turn on arbitrary waveform
generator function and enter waveform generator function menu.
2. Connect the device with PC which has installed the WaveEditor software using a USB
cable.
3. Double click the WaveEditor icon to open the software.
4. Select a waveform file or draw an arbitrary waveform; then click the
in toolbar and
select a waveform data download position to download waveform data to the device.
5.The waveform will output from GEN OUT BNC port.
Also, you can recall ARB format file in USB disk to output a waveform.
1. Press the
【
Wave Gen
】
button on the front panel to enter waveform generator function
menu.
2. Press
waveform
softkey and rotate V0 to select Arb1~Arb4,then press V0 to confirm.
3. Press
recall
softkey and select desired recalled ARB format file in USB disk.
