DPO6000
，
MPO6000 Series Digital Phosphor Oscilloscope Instruction V1.1
- 15 -
2.Front Panel Function Overview
2.1.Main keys introduction
2.1.1.HORIZONTAL
Horizontal Offset
:
Modify the horizontal position. The trigger point would move left or right
relative to the center of the screen when you turn the knob.During the
modification,waveform of all the channels would move left or right and the
horizontal position message at the upper-right corner of the screen would
change accordingly. Press down this knob to quickly reset the horizontal
position.
HORIZONTAL Time Base
:
Modify the horizontal time base. Turn clockwise to reduce the time base
and turn counterclockwise to increase the time base. During the
modification, waveform of all the channels will be displayed in expanded
or compressed mode and the time base message at the upper side of the
screen would change accordingly. Press down this knob to quickly switch
single-window or dual-window display modes.
2.1.2.VERTICAL
analog channel setting keys. Press any key to open the corresponding
channel menu and press again to turn off the channel.
Math
:
Press this key to open the math operation menu,press again to close the
math function
VERTICAL Offset
:
modify the vertical position of the current channel waveform. Turn
clockwise to increase the position and turn counterclockwise to decrease.
During the modification, the waveform would move up and down and the
position message at the lower-left corner of the screen would change
accordingly. Press down this knob to quickly reset the vertical position to
zero.
VERTICAL Voltage
:
modify the vertical scale of the current channel. Turn clockwise to
decrease the scale and turn counterclockwise to increase. During the
modification, the display amplitude of the waveform would enlarge or
reduce. The scale information at the lower side of the screen would
change accordingly. Press down this knob to quickly switch the vertical
scale adjustment mode between "Coarse" and "Fine".
2.1.3.Signal Source
