Hantek DPO6000 Series, Manual

Page: 18 / 116

DPO6000
，
MPO6000 Series Digital Phosphor Oscilloscope Instruction V1.1
- 16 -
Signal Source key :
Press this key to enter the source setting interface to set the output signal
waveform and parameters
Note : This function is only applicable to digital oscilloscopes with signal source function.
2.1.4.TRIGGER
Trigger level :
modify the trigger level. Turn clockwise to increase the level and turn
counterclockwise to reduce the level. During the modification, the trigger
level line would move up and down and the value in the trigger level
message box at the lower-left corner of the screen would change
accordingly. Press down the knob to quickly reset the trigger level to the
trigger data source zero point.
Trig Menu :
press this key to open the trigger operation menu.This oscilloscope provides
various trigger types. For more details, please refer to “Trigger System” .
Force Trig :
Short press this key to generate a trigger signal forcefully.
Long press this key to turn on history waveform.
2.1.5.AUTO
Auto Scale
:
Press this key to enable the waveform auto setting function. The
oscilloscope will automatically adjust the vertical scale,horizontal time base
and trigger mode according to the input signal to realize optimum waveform
display.
2.1.6.RUN/STOP
Run/Stop :
press this key to "RUN" or "STOP" waveform sampling. In the "RUN" state,
the key is illuminated in green. In the "STOP" state, the key is illuminated in
red.
2.1.7.SINGLE
Single :
Press this key to set the trigger mode to "Single". In single trigger mode,
press FORCE to generate a trigger signal immediately.
2.1.8.Multifunctional Knob
V0 :
Use this knob can do many settings,such as adjusting waveform
brightness,trigger time,selecting trigger types,selecting trigger source,the
waveform frequency offset and amplitude of signal source; In
non-menu-operation mode, the indicator light of the knob doesn’t go on, In
menu operation, the indicator light of the knob goes on.Turn this knob can
adjust the settings above, Turn clockwise to increase and counterclockwise
to reduce,press down to select this option.
2.1.9.Function Menus