Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Chapter 2 HGMP V2 Configuration
Commands
2-24
Both switching directions (from the management device to a member device, and from
a member device to the management device) will use Telnet connection. Switching is
performed based on the following rules:
z
Both switching directions will perform authentication. In a switching process, the
system will authenticate the level-3 super password. If the super password on the
device that requests the switching is inconsistent with that on the requested device,
the switching fails. When a candidate device joins the cluster, its super password
will automatically synchronize to the supper password on the management device
(this is not true when you add the candidate device to the cluster using the
administrator-address
command). It is recommended not to change the super
password of any cluster member or the management device, so as to avoid
switching failure resulting from authentication failure.
z
After you switch from the management device to a member device, the member
device view will inherit the user privilege level of the current management device
view.
z
After you switch from a member device to the management device, the privilege
level on the management device view will be determined by the configuration on
the management device.
z
If all the Telnet resources on the requested device are used up, the switching to
the device will not succeed.
When you execute this command on the management device with an inexistent
member number or a MAC address that is not in the member list, an error will occur. In
this case, you can enter
quit
to end the switching.
Examples
# Switch from the management device to number-6 member device and then switch
back to the management device.
<aaa_0.Sysname> cluster switch-to 6
<aaa_6.Sysname> quit
<aaa_0.Sysname>
2.3.8 cluster-mac
Syntax
cluster
-
mac H-H-H
undo cluster
-
mac
View
Cluster view
