AMP command list
The AMP commands available in T2 are listed in the following tables. The commands with gray-
colored cells in the list are not supported by T2.
NOTE
•
The latency in the number of frames from the time the command such as Play or Stop is
issued to the time the operation actually starts is not fixed. The video loaded on multiple
T2 cannot be synchronized in the accurate frames by AMP commands.
•
.For AMP specifications and settings, refer to the Grass Valley AMP protocol documents
on our website or the following URL.
http://www.gvgdevelopers.com/concrete/apis/amp_protocol/documentation/
•
For sample source codes of AMP protocol, refer to our website or the following URL.
http://www.gvgdevelopers.com/concrete/apis/amp_protocol/amp-socket-connection-
•
The port number of T2 for connecting AMP is 3811.
•
AMP control sample programs can be downloaded from our website.
Device management
Command
Channel-
less mode
R1
P1/P2
Sync
mode
Fill/Key
signal
output
mode
Supplementary note on T2
operation
01.06
Set Drop
Frame Mode
[DF mode:] setting that is in
[Miscellaneous] of [General]
in the setting screen will be
changed.
Since [DF mode:] is a common
setting for R1/P1/P2, the
setting change will be applied
to the other channels.
00.0C
Local Disable
No
Enabling and disabling of
local control or remote control
can be set for each channel.
0X.1D Local Enable
No
Enabling and disabling of
local control or remote control
can be set for each channel.
00.11
Device Type
Request
0x20 and 0x50 are returned
corresponding to the device
category and the model
number, respectively.
20.04 Standby Off
No
No
No
No
No
258
T2 Elite 2/Pro 2/Express 2/Elite/Pro/Express User Manual
May 16, 2016
Section 12 ― Appendix