Software
English, Revision 09, Date: 13.12.2016
44
5.2.2.10 (W)rite Transponder
Transponders can not only be programmed using the corresponding system com-
mand (see Table 6 on page 20 / Table 11 on page 25) but also by entering
. There-
fore, enter a max. 5 digit code as hex number. Then put a RW transponder in reading
distance in the antenna field and run the programming with
.
5.2.2.11 (L)oad User parameters to EEProm
This submenu enables saving the parameters within a non-volatile memory once the
corresponding password
815
has been entered. This is necessary in order to store
changes as permanent settings.
5.2.2.12 (U)pdate Firmware
This item offers the option of a software update without having to disconnect and re-
connect the power supply. However, first it is necessary to install the update program
as described in section 5.3 on page 45. Then prepare the flash program as follows:
1.
Close the COM port connection in HyperTerminal.
2.
Open the flash program.
3.
Select the COM-Port in the flash program, via which the antenna is currently
connected to your PC.
4.
Select the hex file to be programmed.
5.
Now return to Hyperterm and open the COM port again.
Then press
within the main menu. The password to be entered is the same as listed
in section 5.2.2.11. Explanatory text is shown.
-
Within the next 20 sec. close the COM-Port in Hyperterm e.g. by using the icon
, switch over to the flash program and start the programming.
-
Once the programming is completed, return to Hyperterm, wait 10 sec., re-con-
nect the COM-Port (e. g. via the icon
) and then re-start the monitor mode (as
explained in section 5.2.1 on page 31).
5.2.2.13 Import (1) / export (2) User Parameter
It is possible to store or load all user parameters on or from a host PC via XMODEM file
transfer protocol:
-
With
you can import a parameter file from a host. After pressing that key you
should start an XMODEM file transfer within 50 seconds. When using Hyperterm
go to
Transfer
>
Send file
>
XMODEM
>
File name
. If the message
Success
is
displayed the file has been checked and loaded into the parameter RAM. To pre-
serve the loaded values you should transfer them into the EEPROM (see 5.2.2.11
on page 44).
-
With
you can export user parameters to a host. After pressing that key you
should start an XMODEM file transfer. When using Hyperterm go to
Transfer
>
Receive file
>
XMODEM
>
Folder
and then specify a file name. The file is trans-
ferred and the message
Success
should be displayed.
