Software
English, Revision 09, Date: 13.12.2016
30
If you are using a different port than
COM1
with HyperTerminal, then adjust the port as
follows:
1.
Select Properties from the menu file (or click the Icon
). The following window
appears:
2.
Choose the direct connection to the respective port via the submenu
direct
connection
. Confirm with
. Save the altered values if you are asked for it
while exiting HyperTerminal.
5.2
System Monitor
In
monitor mode
the system can be configured using the corresponding menu. To use
the monitor mode you need to know which protocol is set in your antenna.
The possible communication procedures are:
For changes to the modes and data rates see section 5.2.2.2 on page 35.
character delay
1 ms
line delay
0 ms
PC interface (port)
COM1
can vary depending on the PC (see below)
Modus
Description
Monitor only
Default mode, see section 5.2.2 on page 32
3964R
For direct PLC communication, see annex A on
page 51
Transparent
For direct PLC communication, see annex B on
page 52
Table 19
Monitor modes
Terminal settings monitor program (refer to section 5.2)
Table 18
Terminal settings for the monitor program
