golmar NEXA Series, User Manual

Page: 140 / 146

With the handset lifted:
If programming the telephone as master, replace the handset.
If programming it as slave, press the door release push button, then replace the handset.
IMPORTANT:
If the installation has a CD-PLUS/R5 converter with coded door panel or guard unit, the programming codes assigned to
the telephones must be between 1 and 250. To make it easier for the user to make a call, another parallel code can be
assigned in a 2nd assignment table.
Make a call to check that the telephone has been successfully programmed. Programme the other
telephones in the same way.
After programming, press button C.
Each apartment must only have one master unit; if there are parallel units, whether monitors or telephones, they must be
configured as slaves.
With the door release push button pressed, pick up the telephone's handset.
To show that the system is ready for programming, the door panel and handset will emit a
number of tones, and audio communication can be established.
Release the door release push button.
Enter the code to be called by this telephone and press bell.
At this moment both door panel and handset will emit tones.
Programming T-530 R5 telephones: SU-R5
PROGRAMMING THE TELEPHONES
140
M S
To enter con fi guration mode, press the key button
three times and then enter the secret administrator
pin (factory code 2718) as described on p. 1
. 17
CONFIGURATION
2 7 1 8
****
Master Slave
0 1
0 1
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL WITH DISPLAY
Important:
Programming from coded module:
- With EL632 R5 and EL642 R5 sound module V01 or later / EL632 R5 P/T with V03 or later.
- With N3301/AL or NX3301
V03 or later. access control module
With or display module - N3403/AL NX3403 V05 y posterior.
Bear in mind the number of digits in the configured code (factory setting 2718 = 4).
(1)
(1)