golmar NEXA Series, User Manual

Page: 17 / 146

17
MODULE PROGRAMMING
Programming fields:
Continued overleaf
Continued from previous page
Field “5”
: Configuring the external buttons.
5
Press “5” to select field “5”.
Steps: Field + button + button mode + activation time + key button
6 C
or
(Step 1)
(Step ) 6
Set the external button to select for configuration. Enter one of the following options:
“1”: Select external button PL1.
“2”: Select external button PL2.
Allows external buttons PL1 and PL2 to be configured with the following modes:
- Allows the button to: Always be enabled or, through button codes CP1 or CP2, enable/disable the functioning of the
button.
- Allows an activation time for external buttons PL1 and PL2 of between “01” and “99” seconds for relay 1 and relay 2
outputs respectively. Only takes effect if the relay output of the external button has been configured in impulse mode
(see p. 16,
"step 3 ” ).
Note: External buttons PL1 and PL2 activate relays 1 and 2 respectively.
2 1
(Step ) 3
Set the push button mode selected in step 2.
Enter one of the following options:
“ 0 ” : Always enabled.
“ 1 ” : Enable/disable function with the CP1 button code.
“ 2 ” : Enable/disable function with the CP2 button code.
(Step ) 5 Press the key button to finish programming the field.
Note: It is not necessary to press the key button if it has already been pressed in step 4.
Then press the number of the next field to configure or press the C button (cancel) to exit
programming mode.
5 0 1
or
2
or
2 1
(Step ) 2
0
or or
1 2
or
0 1
or
(Step ) 4
Set the activation time for the external button selected in step 2. Only takes effect if the
relay output has been configured in impulse mode (see p. 16, “ step 3 ” ).
Enter a value from “ 01 ” to “ 99 ” seconds or press the key button.
Note: If the key button is pressed, this field is set with a value of “ 03 ” seconds and the
programming of the field finishes.
1 0
*
( )
*
( )
AUDIO AND VIDEO DOOR ENTRY SYSTEM - ACCESS CONTROL