golmar NEXA Series, User Manual

Page: 19 / 146

19
MODULE PROGRAMMING
Programming fields:
Continued overleaf
Continued from previous page
Field “7”
: Configure the identification ID of the access control module.
(Not configure).
7
Press “ 7 ” to select field “ 7 ” .
Steps: Field + D code + key button. I
8 C
or
(Step 1)
(Step ) 4
Set an identification code (ID) for the access control module.
Note: Possible identification codes (ID):
“ 000 ” to “ 999 ” .
Allows an identification code (ID) to be configured for the access control module.
Note: Possible identification codes (ID): “ 000 ” to “ 999 ” .
IMPORTANT: This programming field for standalone access control. is not applicable
(Step ) 3
Then press the number of the next field to configure or press the C button (cancel) to exit
programming mode.
7
0
0 0
(Step ) 2
0 0 0
Press the key button to finish programming the field.
Field “8”
: Configure depth of field. (Not configure).
8
Press “ 8 ” to select field “ 8 ” .
Steps: Field + number of calling code direct call + key button.
9 C
or
(Step 1)
(Step ) 5
Set the number of digits in the calling code.
Enter one of the following options:
“ 1 ” or “ 2 ” or “ 3 ”
Allows the number of digits in the calling code to be configured.
IMPORTANT: This programming field for standalone access control. is not applicable
(Step ) 4
Then press the number of the next field to configure or press the C button (cancel) to exit
programming mode.
8
(Step ) 2
2 3 1
Press the key button to finish programming the field.
1 2
or
3
or
or or
0 1
or
Set the direct call: by entering a call code on the keypad if necessary or do not press the
key button to confirm.
Enter one of the following options:
“ 0 ” : Disable.
“ 1 ” : Enable.
(Step ) 3
0 1
or
AUDIO AND VIDEO DOOR ENTRY SYSTEM - ACCESS CONTROL