Field
Value
request is received.
Possible values:
•
4
(default value): A negative response to a
request is accepted.
•
' 4
: A negative response to a request is
not accepted. A request is sent to the next RADIUS server
until your device receives a response from a server con-
figured as authoritative.
UDP Port
Enter the UDP port to be used for RADIUS data.
RFC 2138 defines the default ports 1812 for authentication
(1645 in older RFCs) and 1813 for accounting (1646 in older
RFCs). You can obtain the port to be used from the document-
ation for your RADIUS server.
The default value is
E
.
Server Timeout
Enter the maximum wait time between ACCESS_REQUEST
and response in milliseconds.
After timeout, the request is repeated according to Retries or
the next configured RADIUS server is requested.
Possible values are whole numbers between
and
.
The default value is
(1 second).
Alive Check
Here you can activate a check of the accessibility of a RADIUS
server in Status
8
.
An Alive Check is carried out regularly (every 20 seconds) by
sending an ACCESS_REQUEST to the IP address of the RA-
DIUS server. If the server is reachable, Status is set to
4
again. If the RADIUS server is only reachable over a
switched line (dialup connection), this can cause additional
costs if the server is
"8
for a long time.
The function is activated by selecting
"
.
The function is enabled by default.
Retries
Enter the number of retries for cases when there is no re-
Gigaset Communications GmbH
2 System Management
hybird 120 Gigaset Edition
33
