GeoVision GV-BL110D, User Manual, Page: 266 / 393

248
z
To load system default settings:
1. Unplug the power cable or the network cable (if it is also used as the
power supply).
2. Press and hold the Default button (No. 10, Figure 5-1).
3. Power on the camera using the power cable or the PoE cable.
4. Hold the Default button until the two network LEDs fade. This will
take about 25 seconds.
Figure 14-11
5. When default loading is completed, the camera will pan and tilt to its
full range and return to the home point.
Vandal Proof IP Dome
1. Unplug the power cable and the network cable to start.
2. Use a pin to press and hold the Default button on the inner housing.
Figure 14-12