General Dynamics CG-1220, Operation And Maintenance Manual

Page: 107 / 134

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
46
SPU SERIAL LINK STATS
Path:
/ STATUS SPU-DIAG
Type:
Executable
Syntax:
SPU-DIAG
Notes:
Displays the SPU RS422 serial link statistics separated by destination (MCU and
DSP): Timeouts – the CPU did not get a response within 100mSec. Errors –
unexpected responses that do not match the internal protocol. % of Total –
indicates the percentage of errors plus timeouts versus the total number of
commands. Linklosses – counts the number of failures to establish communication
with the MCU or DSP processors. Total – sum total of commands sent.
START
Path:
/ CONFIGS MONOPULSE
Type:
Executable
Syntax:
START
Notes:
START monopulse operation; to stop, use EXIT followed by a carriage return. It
stops automatically if and when a fault is set. After stopping, in either case, the
mute switch is enabled. NOTE: Only usable via the M&C
STATUS (v1.16.51 or later)
Path:
/ STATUS
Type:
Sub Menu
Syntax:
STATUS
Notes:
The STATUS menu contains useful diagnostic tools. The SPECTRAL DISPLAY
option is accessed from this menu, as are other tools, such as a I/O status and the
message log. This parameter was called DIAGS prior to v1.16.51.
STORE BEACONS
Path:
/ CONFIGS BEACONS STORE-BEACONS
Type:
Sub Menu
Syntax:
STORE-BEACONS
Notes:
Executing each item in this menu will STORE CURRENT values of the following
parameters as a BEACON state: FREQUENCY, INPUT ATTEN, POL SELECT, FILTER,
SLOPE, VOLT RANGE, MIN REF LVL, and ATTENUATION.