General Dynamics CG-1220, Operation And Maintenance Manual

Page: 3 / 134

NOTICES
WARNING
THE ELECTRICAL CURRENTS AND VOLTAGES IN THIS EQUIPMENT ARE DANGEROUS. PERSONNEL
MUST OBSERVE SAFETY REGULATIONS AT ALL TIMES.
This manual is intended as a general guide for trained and qualified personnel who are aware of the
dangers of handling potentially hazardous electrical and electronic circuits. This manual is not intended
to contain a complete statement of all safety precautions that should be observed by personnel in
using this or other electronic equipment.
WARNING
IN CASE OF EMERGENCY BE SURE THAT POWER IS DISCONNECTED.
The manufacturer has attempted to detail in this manual all areas of possible danger to personnel in
connection with the use of this equipment. Personnel should use caution when installing, operating,
and servicing this equipment. Care should be taken to avoid electrical shock, whether the hazard is
caused by design or malfunction.
WARNING
ALWAYS DISCONNECT POWER BEFORE OPENING COVERS, ENCLOSURES, PANELS, OR SHIELDS.
ALWAYS USE GROUNDING STICKS AND SHORT OUT HIGH VOLTAGE POINTS BEFORE SERVICING.
NEVER MAKE INTERNAL ADJUSTMENTS OR PERFORM MAINTENANCE OR SERVICE WHEN ALONE
OR FATIGUED.
The manufacturer is specifically not liable for any damage or injury arising from improper procedures
or failure to follow the instructions contained in this manual or failure to exercise due care and caution
in the installation, operation, and service of this equipment or use by improperly trained or
inexperienced personnel performing such tasks. During installation and operation of this equipment,
local building codes and fire protection standards must be observed.
PROPRIETARY NOTICE
All computer software, technical data, or other information pertaining to the equipment covered by this
manual is proprietary to General Dynamics SATCOM Technologies (GDST). Such information is
transmitted in this manual or related documents for the benefit of GDST customers and is not to be
disclosed to other parties verbally or in writing without prior written approval of GDST. Additionally,
this manual may not be reproduced in whole or in part without written consent from GDST.
© 2009 – 2012 General Dynamics SATCOM Technologies
iii