General Dynamics CG-1220, Operation And Maintenance Manual

Page: 86 / 134

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, June, 2012)
25
FREQ #3 IF OVERRIDE
Path: / CONFIGS MEMORY CALIBRATION IF-OVERRIDE F3-OVERRIDE
Type:
Data Editor
Syntax:
F3OVERRIDE [= n] | [D]
Range:
Integer: 0 .. 15
0 – Automatic 4 – 829.6 8 – 836.0 12 – 842.4
1 – 824.8 5 – 831.2 9 – 837.6 13 – 844.0
2 – 826.4 6 – 832.8 10 – 839.2 14 – 845.6
3 – 828.0 7 – 834.4 11 – 840.8 15 – 847.2
Notes:
Allows user selection of IF1 used by the L-Band front end for the current frequency.
IF1 specifies an approximate center for the digital filter within a 25MHz analog filter
centered at 836.5.
FREQ #4 IF OVERRIDE
Path:
/ CONFIGS MEMORY CALIBRATION IF-OVERRIDE F4-OVERRIDE
Type:
Data Editor
Syntax:
F4OVERRIDE [= n] | [D]
Range:
Integer: 0 .. 15
0 – Automatic 4 – 829.6 8 – 836.0 12 – 842.4
1 – 824.8 5 – 831.2 9 – 837.6 13 – 844.0
2 – 826.4 6 – 832.8 10 – 839.2 14 – 845.6
3 – 828.0 7 – 834.4 11 – 840.8 15 – 847.2
Notes:
Allows user selection of IF1 used by the L-Band front end for the current frequency.
IF1 specifies an approximate center for the digital filter within a 25MHz analog filter
centered at 836.5.
FREQUENCY
Path: / FREQUENCY
Type:
Data Editor
Syntax:
FREQUENCY [= n] | [D]
Range:
Real: 945.000 .. 12750.000 (v2.0.7 or later)
Real: 949.000 .. 12750.000 (v2.0.4 or earlier)
Notes:
This is the FREQUENCY editor. The valid frequency range depends on the DTR’s
downconverter configuration.