General Dynamics CG-1220, Operation And Maintenance Manual

Page: 83 / 134

Appendix C– DTR Remote M&C Protocol CG-6073 (Rev R, Jun, 2012)
22
FACTORY CALIBRATION
Path:
/ CONFIGS MEMORY CALIBRATION
Type:
Sub Menu
Syntax:
CALIBRATION
Notes:
Contains system parameters that are calibrated in factory and are NOT normally
changed by the user. CHANGING THE PARAMETERS IN THIS MENU MAY
DEGRADE THE PERFORMANCE OF THE DTR.
FFT SAMPLE AVERAGING
Path:
/ CONFIGS OPERATION AVERAGING
Type:
Data Editor
Syntax:
AVERAGING [= n] | [D]
Range:
Real: 1 .. 2000
Notes:
FFT SAMPLING AVERAGING determines how new FFT data is combined with
previous data. Increasing AVERAGING smoothes the spectral curve and increases
the stability of the display. Decreasing AVERAGING improves response time.
FIFO-STATUS (v1.16.51 or later)
Path:
/ STATUS FIFO-STATUS
Type:
Executable
Syntax:
FIFO-STATUS
Notes:
Displays counts of the following: Status Frames, Signal Frames, Spectrum Frames,
Monopulse Frames, Missing Monopulse Frames, Unknown Frames, Total Frames.
The Missing Monopulse Frames count is caused by requesting monopulse at a rate
higher than the number of monopulse data frames being generated.