Geely EC715 2009, Workshop Manual

Page: 700 / 2181

Terminal
ID
Name Wiring Terminal Instructions Status Specified Conditions
42-45 -- -- -- -- --
46 O2B_HTR 0.75 B/O
Post-Catalytic Oxygen
Sensor Heating
Heating PWM Wave
47-50 -- -- -- -- --
51 A/C Relay 0.5 B/Y
Air-Conditioning
Compressor Relay
Air-Conditioning Switch UB or GND
52-54 -- -- -- -- --
55 O2BLO 0.5 L/R
Post-Catalytic Oxygen
Sensor A-Side
Ignition Switch "ON" 0-5 V
56-61 -- -- -- -- --
62 MPR 0.5 B/L Main Relay All UB
63-64 -- -- -- -- --
65 0.5 P Air-Conditioning Request Ignition Switch "ON" UB orGND
66 FANHI 0.5 B/O High-Speed Fan Relay
Coolant Temperature
That Activates High-
Speed Fan
UB or GND
67 FANLO 0.5 L Low-Speed Fan Relay
Coolant Temperature
That Activates Low-
Speed Fan
UB or GND
68-70 -- -- -- -- --
71 FPR(HSD) 0.5 G Oil Pump Relay Ignition Switch "ON" UB or GND
72 SDATA 0.5 Gr/P Data Link Connector Using PWM Wave
73 PWRGND 4 B Power Ground All GND
2.12.7.6 DTC Code Type Definition
In the diagnosis calibration settings, different fault type settings have different fault lamps light timing and methods. Fault type is
divided into A, B, C, E, Z, their definitions and fault lamps light principles are as following :
Fault Type Emission-Related Definition
A-type Yes Occurring once MIL lamp will be lit and a DTC code will be recorded
B-type Yes
Occurring once in each two consecutive trips, MIL lamp will be lit and a DTC code will
be recorded.
E-type Yes
Occurring once in each three consecutive trips, MIL lamp will be lit and a DTC code will
be recorded.
C-type No
Record the DTC code when the fault occurs, but the MIL lamp will not be lit, SVS lamps
may be lit.
2-618 Control System JL4G15-D Engine
EC718/EC718RV EC715/EC715RV 10/2009