Geely EC715 2009, Workshop Manual

Page: 436 / 2181

FE02-0135b
12. Rotate the crankshaft, so that the crankshaft pulley timing
mark is aligned with calibration line No.0, as shown.
B
C
D
A
Timing Chain Cover Surface
FE02-0143b
13. Make sure intake and exhaust VVT sprocket sprocket
timing mark location is as shown in order to ensure that
the cylinder No.1 is at TDC position. If the location is not
correct, repeat steps 12 until the intake and exhaust
sprocket timing mark is at the correct position and mark
on the sprocket with a marker.
Note
Exhaust sprocket has three marked positions, with
two-point upward. VVT sprocket has three marked
positions. Grooves on the aluminum alloy body are
upward, in the alignment process, the yellow section
of the chain may not be aligned with the mark-point.
During the removal procedure, make sure two
sprocket timing marks at the top location, single-
point mark on the sprocket at the level of linear
position.
2-354 Engine Mechanical System JL4G18-D Engine
EC718/EC718RV EC715/EC715RV 10/2009