Geely EC715 2009, Workshop Manual

Page: 870 / 2181

(d) Start and run the engine at idle speed to warm up the engine
for at least 5 min.
(e) Road test the vehicle for at least 10 min.
(f) Read control system DTC code again to confirm that the
system has no DTC code.
No
Intermittent Fault. Refer to
2.12.7.3 Intermittent Fault Check
Yes
Step 7
Diagnostic completed.
2.12.7.56 DTC P2610
Lack of information, to provide in the future.
2.12.7.57 DTC P0633 U0167 U0426
1. DTC Descriptor:
DTC P0633 Alarm Does Not Learn Malfunction
DTC U0167 Anti-theft Device No Response
DTC U0426 Anti-theft Device Authentication Failure
ECM communicates with Anti-theft control module through ECM harness connector EO01 terminal No.62 R-LIN circuit and wiring
harness connector EO35 terminal No.72 R-LIN circuit. For details, Refer to
11.17 Data Communication System .
2. Conditions For Setting DTC and The Fault Location:
DTC Code DTC Detection Strategy
Conditions For Setting The
DTC (Control Strategy)
Fault Locations
P0633 Alarm Does Not Learn Malfunction Ignition Switch "ON".
1. Ignition Key
2. Ignition Key Incentive Coil
3. ECM
4. Chip Security Module
5. Data Circuit (W-LIN Circuit,
R-LIN Circuit)
U0167 Anti-theft Device No Response Ignition Switch "ON".
1. Ignition Key
2. Ignition Key Incentive Coil
3. ECM
4. Chip Security Module
5. Data Circuit (W-LIN Circuit,
R-LIN Circuit)
2-788 Control System JL4G15-D Engine
EC718/EC718RV EC715/EC715RV 10/2009