Geely EC715 2009, Workshop Manual

Page: 364 / 2181

B3060 Anti-theft transponder verification failed. X 9
B3061 EFI controller verification failed. X 10
Note
DTC (DTC code) is set based on the above-mentioned output sequence. But at the same time it only shows a maximum
of 7 DTC.
Note
DTC code history is code recorded before shown by the scan tool. If a DTC code has no historical features, it only
shows the current status. If there are historical features it can display the status up to 20 ignition cycles.
2.5.7.5 Data Flow Table
Serial
Number
Name
Data
1 Ignition Switch Position At ON Position
2 Anti-theft Controller Hardware Malfunction No Fault
3 Coil Malfunction No Fault
4 Anti-theft Transponder Yes
5 The Current Key Match Have matched
6 The Current Key Position Position 3
7 Key Storage Position 1 Not Stored
8 Key Storage Position 2 Not Stored
9 Key Storage Position 3 Stored
10 Key Storage Position 4 Stored
11 Key Storage Position 5 Stored
12 Security Certification Passed
13 Anti-theft Verification Yes
14 Password Settings Yes
15 Password Lock No
16 Remaining Numbers Of Times Entering The Password 10
2.5.7.6 Fault Symptom Table
Symptoms Suspect Part Refer to Page
Engine Anti-theft Indicator Always On Instrument Panel
Refer to 11.7.7.1 Instrument
Cluster Replacement .
Engine Anti-theft warning lamp flashes frequently, the engine
can not start.
1. the key
Refer to 2.5.7.12 Engine Anti-
theft Warning Lamp Flashing,
Vehicle Can Not Start
.
2. Anti-theft Coil
2-282 Engine Anti-theft System JL4G18-D Engine
EC718/EC718RV EC715/EC715RV 10/2009