Geely EC715 2009, Workshop Manual

Page: 1466 / 2181

Energy Saving Feature
In order to avoid the electric load (interior lighting, etc.) working
a long time leads to the vehicle battery over-discharge after the
engine is shut down, 2 min after the ignition switch is turned to
"OFF" position, if there is no change in the ignition switch, door
status or unlock command, BCM will cut off the interior lighting
power supply. Open or close any door, energy saving feature
will begin timing. If the above-mentioned status has not
changed for 20 min, BCM will cut off the interior lighting power
supply. If the above-mentioned status has changed within 20
min, BCM will re-start timing 20 min.
When BCM receives the unlock command, the energy saving
feature will start timing. If there is no change in the above-
mentioned status for 20 min, BCM will cut off the interior lighting
power supply. If there is change in the above-mentioned status
within 20 min, BCM will restart 20 min timing. When the ignition
switch is at "ON" position, the energy saving feature will start
timing. After 20 min, BCM will not cut off the interior lighting
power supply. When the ignition switch is at "OFF" position, the
energy saving feature will start timing. If there is no change in
the above-mentioned status in 20 min, BCM will cut off the
interior lighting power supply. If there is a change in the above-
mentioned status in 20 min, BCM will restart 20 min timing.
Emergency Braking Warning Flash
Trigger Conditions:
A. The current vehicle speed is greater than or equal to 45 km/
h (if less than 45 km/h, even if emergency braking is
detected, it will not trigger).
B. The brake pedal is currently pressed and held in position.
C. Hazard alarm switch is not manually turned on.
D. Emergency braking operation has been detected.
E. Emergency deceleration value reaches the pre-set value.
Stop Conditions:
A. Emergency brake alarm flash is triggered after running time
no less than 1,000 ms (either manual or automatic switch
off).
B. Manually switch off the hazard flash switch.
C. Brake pedal has been released.
D. Vehicle start to accelerate again, that is during the 2,000
ms speed sampling time, the vehicle acceleration value is
greater than or equal to the pre-set value.
E. If triggered, the vehicle is in a stopped status, then it
continues to run until the vehicle acceleration is detected,
and acceleration value meets the pre-set value.
Other Features
1. Seat Heating Controller Working Control
Voltage signal is received from CAN, when the battery
voltage is greater than 10.7 V, and the ignition switch is at
"ON" position, the seat heater relay can be activated and
heated seats work properly. When the detected battery
voltage is less than 10.3 V, the seat heaters are not allowed
to work.
2. CAN bus communication capabilities
3. LIN bus communication capabilities
10-6 Computer / Integrated Systems Vehicle Control System
EC718/EC718RV EC715/EC715RV 10/2009