CHAPTER 4: FIELDBUS INTERFACE
DEVICENET PROTOCOL
MM300 MOTOR MANAGEMENT SYSTEM – COMMUNICATIONS GUIDE
4–53
13. When the software has finished browsing, the network displayed on your screen
should appear similar to the one shown below. MM300, Scanner and the 1770 KFD
modules will appear with MACIDs just below each device.
14. After the network is uploaded, the next step is to set the node address of the 1747 SDN
scanner and to configure the scan list.
Set the 1747 SDN Node Address
Once the devices are uploaded, their node addresses appear to the right of their icons. To
change a module’s node address, use the following procedure:
1.
From the
Tools
menu, choose
Node Commissioning
. The Node Commissioning dialog
appears:
