GE LOGIQ 7, Basic User Manual

Page: 275 / 984

Annotating an Image
LOGIQ 7 Basic User Manual 6
-
11
Direction 2392206-100 Rev. 1
Introduction (continued)
In annotation mode, text can be added by using the Touch Panel
Menu library or by typing from the alphanumeric keyboard.
Annotations can be erased by changing modes, powering down,
or when
Clear or New Patient are pressed.
In addition, the display’s home position can be changed
(preferred annotation area) for each display so that all
subsequent annotations begin in the same spot.
Pressing the F7 (Cursor Home) key returns to the user
specified position or factory default position.
A new cursor home position is established by placing the cursor
in the desired position and pressing
Shift+Home.
Annotation Mode is activated by pressing the Comment key.
Annotation Mode can also be automatically activated by typing
from the alphanumeric keyboard.
NOTE: In this case, the cursor begins at the same location where the
annotation mode was exited.
After activating the annotation mode, a vertical bar type cursor
appears on the screen. Use the
Trackball to move the cursor.
The factory default color for annotations is yellow. The color
selection can be changed to any of the colors available on the
system. The choices are white, yellow, bright red, orange, etc.
NOTE: The user cannot change the Font Family and Size.
To indicate a specific annotation or text group is selected, the
color turns to green. Once the annotation is set or fixed, the
color returns to yellow or to the user selected color.
To delete comments by character, press the Backspace key.
To delete all annotations and arrow marks, press the Clear key
twice immediately after entering the annotation mode.
To end the Comment/Library Annotation function, press Set .
To move by words or by text group, press the Tab key.