GE Medical Systems LOGIQ ?200, Service Manual, Page: 34 / 212

GE MEDICAL SYSTEMS
LOGIQ
α
200 SERVICE MANUAL
2138853
INTRODUCTION
1–18
REV 0
1–3 EMC (Electromagnetic Compatibility)
1–3–1 EMC Performance
All types of electronic equipment may characteristically cause electromagnetic interference with other equipment,
either through air or connecting cables. The term EMC (Electromagnetic Compatibility) indicates capability of the
equipment, which curbs electromagnetic influence from other equipment and at the same time does not affect
other equipment with similar electromagnetic radiation from itself.
This product is designated to fully comply with EN60601–1–2 (IEC 601–1–2), In Medical electronic equipment
EMC regulations.
Proper installation following this service manual is required in order to achieve the full EMC performance of the
product.
The product must be installed as stipulated in 1–3–2, Notice upon Installation of Product.
In case of issues related to EMC, please follow procedures stated in 1–3–4, Countermeasures against
EMC-related Issues.
1–3–2 Notice upon Installation of Product
1) Use either power supply cords provided or designated by GEMS or SGMS. Products equipped with
power source plug should be plugged into the fixed power socket which has the protective grounding
conductor.
Connect a three-pole plug to a three-pole socket without using a three-pole-to-two-pole converter.
2) Locate the equipment as far as possible from other electronic equipment.
3) Be sure to use cables provided by GEMS and SGMS. Wire these cables following these installation
procedures.
(Example) Wire power cables separately from signal cables.
4) Lay out the main equipment and other peripherals following the installation procedures described in
Chapter2, INSTALLATION.