Gateway ALR 9250R, User Manual

Page: 74 / 226

60 Gateway ALR 9250R User’s Guide
4.
Push the ejector levers on the socket ends to the upright position.
5. Repeat steps two through four to install each DIMM.
6.
Reinstall the memory module (see “Installing the memory module” on
page 60).
7. Reinstall the top cover using the original screws.
8.
Connect all external cables and the power cords to the system.
9. Turn on the monitor and then the system.
10. Run the SSU (see “Resource configuration add-in” on page 109) to
configure the system and to properly attribute ECC memory.
Installing the memory module
Once you have installed any DIMMs that you want, you must re-install the
memory module.
1. Observe the safety and ESD precautions in “Static electricity
precautions” on page 2.
To Install the Memory Module
Note:
DIMM slots on the memory
module must be installed
only in certain
configurations. See
“Memory configuration” on
page 56 for requirements.
9250R.book Page 60 Friday, April 9, 1999 9:44 AM