Gateway ALR 9250R, User Manual

Page: 138 / 226

124 Gateway ALR 9250R User’s Guide
Power-on self test
Each time you turn on the system, the power-on self test (POST) runs.
POST checks the system board, processors, memory, keyboard, and most
installed peripheral devices. During the memory test, POST displays the
amount of memory it is able to access and test. The length of time needed to
test memory depends on the amount of memory installed. POST is stored
in flash memory.
1.
Turn on the monitor and the system. After a few seconds, POST
begins to run.
2. After the memory test, these screen prompts and messages appear:
Keyboard Detected
Mouse Initialized
Press <F2> to enter Setup
3.
If you do not press
F
2
and there is no device with an OS loaded, the
above message remains for a few seconds while the boot process
continues, and the system beeps once. Then this message appears:
Operating System not found
If you do not press
F
2
and do have a device with an OS loaded, the
boot process continues and this message appears:
Press <Ctrl><C> to enter SCSI Utility
4.
Press
C
TRL
+
C
if SCSI devices are installed. When the utility opens,
follow the displayed instructions to configure the onboard SCSI host
adapter settings and to run the SCSI utilities. Also see “Using the
Symbios SCSI utility” on page 149. If you do not enter the SCSI
utility, the boot process continues.
5. Press
E
SC
during POST to access a boot menu when POST finishes.
From this menu, you can choose the boot device or enter BIOS Setup.
To Use POST
9250R.book Page 124 Friday, April 9, 1999 9:44 AM