Galvanic Applied Sciences MONITEK MESSENGER, User Manual

Page: 16 / 87

-14-
The product is pre-configured at the Factory for the dedicated sensor hardware.
So in most cases, you may not need to change the jumpers on the Main board. If
you really need to change the settings, please write down the original setting
before changing any settings.
1.3.3 Sensor wiring and connections:
The table below shows a typical Forward Side scatter sensor connections to a
Messenger.
MONITURB FS (Forward and Side Scatter) Flow cell.
Terminal Wire color Cable ID Signal
1 Brown FS module (-) Direct beam
2 White FS module (+) Direct Beam
3 Black FS module (AC-GND) Shield
4 Yellow FS module (-) 12 Deg. Sensor
5 Green FS module (+) 12 Deg. Sensor
6 -
7 Yellow SS module (-) 90 Deg. Sensor
8 Green SS module (+) 90 Deg. Sensor
9 Black SS module (AC-GND) Shield
Lamp connections
Terminal
1 Lamp (Blue and Red)
2 Lamp (Grey and Pink)