Fujitsu Primergy CX250 S2, Upgrade And Maintenance Manual

Page: 180 / 264

180 Upgrade and Maintenance Manual
CX250 S2
Main memory
V
CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Operation modes" on page 175 .
7.3.3 Removing a memory module
Figure 96: Removing memory modules (A)
Ê
Eject the desired memory module by pressing out the securing clips at each
end of the memory module connector.
Figure 97: Removing memory modules (B)
Ê
Remove the ejected memory module.
7.3.4 Concluding step
Perform the following procedures:
Ê
"Installing the memory slot air ducts" on page 61
Ê
If a BBU is installed connect the BBU cable to the BBU connector on the
mezzanine SAS RAID controller described in section
"Connectors on the
boards" on page 251 , figure 152 and route the cable as described in section
"Routing the BBU cable" on page 159 .