Fujitsu Primergy CX250 S2, Upgrade And Maintenance Manual

Page: 111 / 264

CX250 S2
Upgrade and Maintenance Manual 111
Expansion cards and battery backup units
6.3.3.3 Removing an expansion card
Ê
Remove the defective expansion card as described in "Removing an
expansion card" on page 107 .
Ê
If applicable, remove SFP+ transceiver modules from the expansion card,
as described in section
"Removing an SFP+ transceiver module" on
page 97 .
Ê
If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
"Mounting expansion card slot
brackets" on page 86 .
6.3.3.4 Installing an expansion card
Ê
If applicable, install a slot bracket on the new expansion card as described
in section
"Mounting expansion card slot brackets" on page 86 .
Ê
If applicable, reinstall SFP+ transceiver modules on the new expansion
card, as described in section
"Installing SFP+ transceiver modules" on
page 92 .
Ê
Install the new expansion card as described in section "Installing an
expansion card" on page 104 .
Ê
If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section "Cabling
overview" on page 246 .
6.3.3.5 Concluding steps
Perform the following procedures:
Ê
"Installing the mezzanine card bracket" on page 49 (without the mezzanine
card) or "Installing the mezzanine card" on page 116 (with the mezzanine
card)
Ê
"Installing the server node in the server enclosure" on page 63
Ê
Reconnect all external cables.
Ê
"Switching on the server node" on page 64
Ê
"Updating RAID controller firmware" on page 73 (if applicable)
Ê
"Enabling boot watchdog functionality" on page 74