Fuji Xerox DocuPrint P255 dw, User Manual

Page: 100 / 252

100 Printer Connection and Software Installation
• Using Ad Hoc Connection
To configure the wireless settings for an ad-hoc connection where the wireless devices communicate
directly with each other without an access point:
1
On the operator panel, press the ( Menu ) button.
2
Select
Admin Menu
, and then press the button.
3
Select
Network
, and then press the button.
4
Select
Wi-Fi Setup
, and then press the button.
5
Select the desired access point, and then press the button.
If the desired access point does not appear:
a
Select
Manual Setup
, and then press the button.
b
Enter the SSID, and then press the button.
Use the or button to enter the desired value, and press the or button to move a
cursor.
c
Select
Ad-hoc
, and then press the button.
d
Select an encryption type, and then press the button.
IMPORTANT:
• Be sure to use one of the supported encryption methods to protect your network traffic.
6
Enter the WEP key, and then press the button.
Use the or button to enter the desired value, and press the or button to move a cursor.
7
Select a transmit key from
WEP Key 1
,
WEP Key 2
,
WEP Key 3
, and
WEP Key 4
.
8
Wait a few minutes until the printer restarts to establish the wireless network.
9
Print a System Settings page from the operator panel.
a
Press the ( Menu ) button.
b
Select
Report/List
, and then press the button.
c
Select
System Settings
, and then press the button.
The System Settings page is printed.
10
Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
• If the wireless setting does not work, contact your system administrator or Fuji Xerox Customer Support
Center.