Fuji Xerox ApeosPort-IV C4430, User Manual

Page: 44 / 393

2 Product Overview
44
P
ro
d
u
c
t O
ver
view
2
Power Source
The machine is provided with the power switch and the main power switch.
„ Power switch
To use the machine, press the power switch
to the [ | ] position to switch its power on. You
can start operations after the machine warms
up.
„ Main power switch
Press the main power switch to the [ ]
position. The <Main Power> indicator goes
out on the right side of the control panel, and
the machine powers off. Do not switch the
main power except when you connect a cable
to the machine or clean the machine. Switching off the main power may erase the data
in the memory when using the Fax service.
Switching the Main Power On
The following describes how to switch the main power on.
Important • Do not switch off the main power immediately after switching on the main power. This may
damage the hard disk and the memory or cause a machine malfunction.
1
Make sure that the power cord is plugged in correctly.
2
Press the main power switch to the [ | ]
position to switch the main power on.
The
<Main Power> indicator lights up on the
control panel.
Switching the Power On
The following describes how to switch the power on.
The machine takes approximately 30 seconds to warm up and to be ready to copy or
print after switching the power on. This may take more time depending on your machine
configuration.
Switch the power off at the end of the day or when not using the machine for an
extended period of time.
Use also the Energy Saver feature to save power consumption while the machine is not
in use.
For information on the Energy Saver feature, refer to"Energy Saver Mode" (P.48).
Important • If the power is switched off, all the services of the machine will stop. When using the
machine throughout the day for jobs such as receiving fax, do not switch the power off.
Power Switch
Main Power Switch