Using Auto-SYNC for Digital Input Connections
222 TIMS MVP
™
Setup and Configuration Guide
In this next example, the black or brightness setting is set too low.
Figure 120: Example of video image where the brightness (Black Level) is too dark
In order to adjust the setting, do the following:
1.
Click your mouse in the Brightness field.
2.
Move your mouse over the black area of the image until you find the value 0,0,0 in the
bottom right hand corner. For example, in the screen example below, move the mouse
to the black box labeled.
3.
Press the up arrow key once to see if the 0,0,0 value increases. If it does not increase
above 0,0,0, then the black value is set too low. Keep pressing the up arrow until you
reach the next value above 0,0,0.
4.
Once you have reached the next value above 0,0,0, then use the down arrow to move
back to the 0,0,0 value. The Brightness is now set properly
In this next example, the value for Brightness is set too high. This means when you move the
mouse cursor over the area which you believe it is set to the correct Brightness value of 0,0,0, it
is higher than that value. In this example, you can see the value is set to 0,3,9.
Move the cursor over the area that you believe is
set to the correct black value.
Summary of Contents for TIMS 2000 EN
Page 1: ...060000 91 Rev 1...