Fluke PG9000 Series, Operation And Maintenance Manual

Page: 16 / 202

PG9602™ OPERATION AND MAINTENANCE MANUAL
© 2011 Fluke Calibration Page
6
1.2.3 Mass Sets
Note
A mass set delivered with a PG7000 is compatible with PG9602, however be
sure to be aware of potential differences between the nominal makeup mass
value and the nominal Piston mass + Mass Bell mass (i.e. using a 4.5 kg MKUP
mass with a 1 kg bell).
All masses are delivered in molded, reusable, transit cases with custom inserts.
Masses > 50g
Material
Finish
Adjustment Tolerance
Uncertainty of Measured Values
304L non-magnetic stainless steel
Electro polished
±
20 ppm of nominal value (manual AND AMH mass sets do
not have fixed adjustment tolerances)
±
5 ppm or 1 mg, whichever is greater
Masses < 50g
±
1 mg
1.2.4 Pressure Measurements
Note
For uncertainty in piston-cylinder effective area and typical measurement
uncertainty in pressure defined by the piston gauge, see the piston-
cylinder calibration report and current revision of Fluke Calibration
Technical Note 0180TN12, “Typical Pressure Measurement Uncertainty for
a PG9607 and PG9602 Piston Gauge”.
PC-7100/7600-10
PC-7100/7600-10-L
Sensitivity
1
Reproducibility
2
Typical Drop Rate (35 kg)
0.02 Pa + 0.5 ppm
±
2 ppm
0.2 mm/min
PC-7100/7600-20
Sensitivity
1
Reproducibility
2
Typical Drop Rate (35 kg)
0.04 Pa + 0.5 ppm
±
2 ppm
0.3 mm/min
PC-7100/7600-50
Sensitivity
1
Reproducibility
2
Typical Drop Rate (35 kg)
0.1 Pa + 0.5 ppm
±
2 ppm
0.5 mm/min
PC-7100/7600-100
Sensitivity
1
Reproducibility
2
Typical Drop Rate (35 kg)
0.2 Pa + 0.5 ppm
±
3 ppm
0.7 mm/min
1
Sensitivity: The smallest variation in input detectable in output.
2
Reproducibility: The root sum square of the stability of effective area and stability of the
AMH-100 mass set for 1 year. Refer to Fluke Calibration Technical Note 0180TN12
.