Fluke PG9000 Series, Operation And Maintenance Manual

Page: 15 / 202

1. INTRODUCTION
Page 5 © 2011 Fluke Calibration
1.2.2 Piston-Cylinder Modules
All piston-cylinders are complete integrated metrological assemblies that include mounting
hardware, upper and lower travel stops, spring preloading system, and are delivered in
individual shipping and storage “bullet” cases.
Gas operated, gas lubricated piston-cylinders (PC-7100/7600) used with PG7000 are
compatible with PG9602.
Note
A piston-cylinder delivered with a PG7102 or PG7601 is compatible with
PG9602; however its metrological properties must be recertified for
operation to determine uncertainty at higher mass loads. Existing
PC-7100/7600-200 (200 kPa/kg) piston-cylinders are supported only up to
the mass set for which they were originally certified (35 kg or 55 kg if it
was delivered with a PG7102).
PC-7100/7600-10, TC
PC-7100/7600-10-L
Operation
Piston Material
Cylinder Material
Nominal Diameter
Nominal Area
Mounting System
Gas operated, gas lubricated
Tungsten carbide
Tungsten carbide
35 mm
1 000 mm
2
Simple free deformation
PC-7100/7600-20
Operation
Piston Material
Cylinder Material
Nominal Diameter
Nominal Area
Mounting System
Gas operated, gas lubricated
Tungsten carbide
Tungsten carbide
25 mm
500 mm
2
Simple free deformation
PC-7100/7600-50
Operation
Piston Material
Cylinder Material
Nominal Diameter
Nominal Area
Mounting system
Gas operated, gas lubricated
Tungsten carbide
Tungsten carbide
16 mm
200 mm
2
Negative free deformation
PC-7100/7600-100
Operation
Piston Material
Cylinder Material
Nominal Diameter
Nominal Area
Mounting System
Gas operated, gas lubricated
Tungsten carbide
Tungsten carbide
11 mm
98 mm
2
Negative free deformation